APM Pixhawk Power Module with XT 60

A battery Eliminator circuit is a type of voltage regulator.it is used to prevent high voltage towards the Escs and pass the required voltage which is essential. As modern RC airplanes use high voltage batteries, it allows you to run your receiver, servos, and other accessories from your main battery without using a separate lower voltage one.

TheAPM 2.5.2/2.6/2.8Pixhawk Power Module is a simple way of providing yourAPM 2.5with clean power from a LiPo battery as well as current consumption and battery voltage measurements, all through a6-poscable. The on-board switching regulator outputs5.3Vand a maximum of2.25Afrom a2S-6S LiPo battery.The Power Module comes completely assembled with Deans or T connectors, and wrapped in shrink tubing for protection. Also, the circuit detects a sensing current around90 A.

Note:

The Power Module is only designed to power APM, an RC receiver, and APM accessories (GPS, 3DR radio). It is not designed to power the servos. Use your aircrafts own ESC/BEC for that.

Features:

1. Voltage and current measurement configured for 5V ADC.
2. Switching regulator outputs 5.3V and 3A max.
3. 6-pos DF13 cable plugs directly to APM 2.5s PM connector.
4. Supports from 2 cell to 6 cell battery.